Just about to wrap up the pan build out, so onto the brake lines. Fresh hardlines are really the best way to go.

I also added some braided stainless lines up front up to those Wilwood calipers.

New fittings and hard lines out back

Finishing it off with new soft lines to the all refreshed rear drum brakes and the back is done.

And onto the front to finish off this roller

Front hard lines are bent and plumbed to the dual circuit Master Cylinder.

Bowden tube and clutch cable in. Its so much easier to do all this stuff with the body off.

And lastly the pedal cluster was installed and adjusted.

Next up is bleeding the brakes, and finishing up the axle build and install. Its almost time to get the body back on and start the full cleanup of the paint.